HEL AN hose end fitting
Buying guide

AN Fittings and Hose Explained: Sizes, Types and How to Build a Line

AN fittings are the standard for fuel, oil and coolant lines in motorsport. Once you know the sizes and hose types, building your own lines is straightforward.

AN (Army-Navy) fittings seal on a 37° flare, metal to metal, so there are no O-rings to fail and you can disconnect and reconnect them again and again. That is why they are used for fuel systems, oil coolers, turbo feeds and brake lines on competition cars.

620+HEL hose and fittings
AN3–AN12the common motorsport sizes
37°flare seal, metal to metal

What the sizes mean

The AN number is the tube size in sixteenths of an inch. AN6 is 6/16" (3/8"), AN8 is 1/2" and so on. As a rough guide:

Size Typical use
AN3 Brake and clutch lines
AN4 Turbo oil feeds, gauge lines
AN6 Fuel feed and return on most engines
AN8 High-flow fuel, oil cooler lines
AN10–AN12 Dry sump, large oil cooler and breather lines

Pick your hose

General purposeBraided rubber

Flexible and easy to route. Good for oil and coolant.

Shop hose ends →
FuelBraided PTFE

Resists modern fuels and ethanol, and stops fuel smell soaking through.

AN8 PTFE fitting · £17.07 →
Quick buildsPush-lock

Push the hose on, no clamps or sockets. Low-pressure use only.

AN8 push-lock · £16.27 →

How to build a line

Measure and cut

Wrap tape around the hose and cut through it for a clean end on braided hose.

Fit the socket

Push the hose into the socket and mark the hose at the socket edge.

Fit the nipple

Lubricate and screw it in until it nearly meets the socket. Check your mark has not moved.

Test

Pressure test before use and recheck after the first run.

💡 Adapters and banjos

Most engines use metric threads. Male-to-male adapters convert to AN, and banjo bolts handle tight spaces.

Common questions

Can I use rubber hose for fuel?

Braided rubber works with standard petrol, but PTFE is better for ethanol blends and stops fuel smell soaking through.

Do AN fittings need thread sealant?

No, they seal on the flare. Only tapered pipe threads such as NPT need sealant.

What size fuel line do I need?

AN6 suits most engines; higher-power cars often go to AN8. Ask us for your setup.

Planning a fuel or oil system?

Send us your plan and we will put together the hose and fittings list.

📞 Call 0333 444 4304Shop AN hose & fittings
Back to blog