Share
Rod Ends and Spherical Bearings: How to Choose the Right One
Rod ends replace rubber bushes with a precise, adjustable joint. Here is how to read the part numbers and pick the right one for your link.
By Race Rally Supplies · 5 minute read
Also called rose joints or heim joints, rod ends let a suspension link pivot freely without the flex of a rubber bush. They are used on wishbones, tie rods, anti-roll bar drop links, panhard rods and pedal boxes. Choosing one comes down to four things: bore, thread, hand and construction.
Four things to choose
The hole for the bolt, for example 3/8" or 1/2".
The shank thread, usually UNF on motorsport parts, male or female.
Use one left-hand and one right-hand on a link so you can adjust its length without removing it.
Two-piece or three-piece, and the liner type.
Two-piece vs three-piece
| Two-piece | Three-piece | |
|---|---|---|
| Build | Ball swaged into the body | Ball held in a separate race |
| Strength | Good | Higher, for high-load positions |
| Price | Lower | Higher |
| Typical use | Linkages, lighter loads | Suspension and steering |
Popular choices
Bearings that press into a housing, such as an upright or arm.
NMB ABT9 · £23.99 →Rod ends wear over time. Check for play at every service and replace any that knock or feel loose.
Common questions
What does Teflon-lined mean?
A low-friction liner between the ball and the race, so the joint moves smoothly and needs no grease.
Can I use rod ends on a road car?
They transmit more noise and need more frequent checks than rubber. They are best suited to competition cars.
Do I need misalignment spacers?
They let the joint articulate further without binding. They are often used on suspension links.
Need help matching a rod end?
Send us the old part or its measurements and we will find a match.
📞 Call 0333 444 4304Shop rod ends